Rust Repair and Welding near Carshalton, 5 Minutes Away

Carshalton's tree-lined streets look lovely in autumn, but wet leaves blocking a car's drain holes are a common reason sills and floors rot from the inside. Our workshop is around 5 minutes from Carshalton, and we repair corrosion properly with new steel, sealed and protected.

  • ★★★★★ 4.9/5 from 193 Google reviews
  • ~5 min from Carshalton
  • Mon–Fri 8am–8pm · Sat 8am–5pm
Car raised on the ramp for underbody inspection at KITH Cars Garage & Bodyworks, Hackbridge

Leaves, blocked drains and the sills of Carshalton's kerbside cars

Around Carshalton Park and down Ruskin Road, big trees line many of the streets, and most cars live on the road rather than in a garage. Every autumn leaves and seeds collect in the scuttle panel below the windscreen, in the sunroof drains and along the bottom of the doors. Once those drains block, rainwater has nowhere to go, and it runs into the sills or sits on the floor under the carpet. Rust then starts inside the box sections, where nobody sees it until the paint bubbles.

The narrow Victorian and Edwardian streets add another problem. With cars parked on both sides, drivers often mount the kerb to let traffic through or tuck in tight, and a sill or jacking point that scrapes the kerb loses its protective coating. Bare steel in that spot rusts quickly. On an older car, that small patch can turn into a hole that fails the MOT within a couple of winters. The same goes for the sill seams, where a scrape can open up the factory sealer and let water in behind it.

We look at both causes. On the ramp we probe the sills, inner arches and floor, then check the drains and door bottoms so the repair isn't let down by the same blockage. Rotten metal is cut back to sound steel and a new section is welded in. Afterwards the enclosed sections are treated with cavity wax, which creeps into the seams and slows rust from the inside, the very place Carshalton's leaf-fall tends to attack.

Drivers from Carshalton on the Hill and Oaks Park often bring older family cars that are otherwise in good order, and a sill repair on one of those is usually worth doing. You get a written quote before anything is cut, and if the rust turns out worse once opened up, we call you first. Our 12-month workmanship warranty covers the repair.

Welding & Rust Repair: what’s involved

Most cars have a monocoque body, meaning the shell itself acts as the chassis. Sills, floor pans, crossmembers and the areas around suspension and seat belt mountings carry load, so rust there weakens the car. Corrosion usually starts where water and road salt collect: inside sills, behind arch liners, along seams and around jacking points, and it often works from the inside out.

The MOT treats corrosion seriously. Excessive corrosion in load-bearing structure is a failure, particularly within 30cm of prescribed areas such as suspension, steering and seat belt mounting points. A proper repair means cutting back to sound metal, fitting a new steel section and welding it in, then sealing and protecting it inside and out. Covering rust with filler or a plate over rotten metal doesn't fix it, and a tester can fail an inadequate repair on a structural area.

From £80Written quote first
2 hours – 3 daysTypical time in the workshop
3 monthsWorkmanship warranty
4.9★193 Google reviews

Signs of rust that needs welding

Bubbling paint on sills or arches

Rust forming underneath the paint. It's usually more extensive than the visible bubbles suggest.

Holes or flaking metal underneath

Floor pans, sills, jacking points and crossmembers that flake or can be pushed through with a probe.

MOT advisory or failure for corrosion

An advisory is a warning worth acting on; a failure for structural corrosion must be repaired before the car can pass.

Soft or crumbling jacking points

If the sill crushes or the jack sinks into it, the structure around it is weakened.

Rust around suspension mountings

Corrosion near spring seats, strut tops, subframe or trailing arm mounts is structural and needs prompt repair.

Water in the footwells

Can be caused by holes in the floor, although blocked drains and door seals are more common causes, so we check.

Rust on door bottoms and boot floor

Often cosmetic rather than structural, but cheapest to repair while the rusted area is still small.

When should it be done?

Deal with structural rust as soon as it's found, ideally before the MOT so you have time to plan. Corrosion advisories are worth acting on, because another winter of salted roads can turn an advisory into a failure needing bigger repairs. Cosmetic rust on door bottoms or arch edges isn't a safety issue, but it's cheapest to fix while it's still at the bubbling stage. Older and classic cars benefit from a regular underside inspection.

  • MOT advisory mentioning corrosion: before the next winter or MOT
  • MOT failure for corrosion: before retest, and before driving at all if the defect was rated dangerous
  • Bubbling paint on sills, arches or door bottoms: while the rust is still small
  • Buying an older or classic car: underside inspection before or soon after purchase

How we repair rust and welding

  1. Inspection on the rampWe examine the underside, probe suspect areas and read any MOT failure sheet, separating structural corrosion from cosmetic.
  2. Written quoteWe explain what's structural, what's cosmetic and what should be prioritised. Rust sometimes proves more extensive once cut into, and we'll contact you before doing anything extra.
  3. Access and protectionTrim, arch liners, seats or carpets are removed as needed, and fuel lines, brake pipes and wiring are protected or moved away from heat.
  4. Cut out corrosionRusted metal is cut back until we reach clean, sound steel.
  5. Fabricate or fit repair sectionsNew steel sections are formed in the workshop, or pre-formed repair panels are used where available and a good fit.
  6. Weld inThe new metal is MIG welded in, seam welded where the structure requires it, and the welds are dressed back.
  7. Seal and protectJoints are seam sealed and primed, the underside is coated with underbody protection and enclosed sections are treated with cavity wax.
  8. Refit, check and hand overEverything is refitted, pipes and wiring are checked, and we explain what was repaired and anything else worth watching.

Steel and materials

Repairs are made with new steel of a suitable thickness for the area, either fabricated in the workshop or using pre-formed repair panels where they're available and fit well. After welding, joints are sealed, primed and protected with underbody coating, and enclosed sections such as sills are treated with cavity wax, which creeps into seams to slow future corrosion from the inside.

  • New steel sheet of the appropriate thickness
  • Pre-formed sill and arch repair panels where suitable
  • Weld-through primer and anti-corrosion primer
  • Seam sealer
  • Underbody protection and cavity wax

How long it takes

2 hours – 3 days

A single small MOT repair can often be done in 2–4 hours. Sills, floor sections or several areas can take 1–3 days, and extensive work on older cars longer. If the rust turns out to be worse once cut out, we'll call you before going further.

What’s included

  • Underside inspection and written quote
  • Cutting out corrosion back to sound metal
  • New steel welded in
  • Seam sealing, priming and underbody protection on the repair
  • Cavity wax in enclosed sections that have been repaired
  • 12-month workmanship warranty

From Carshalton to our Hackbridge workshop

From Carshalton village, head north on West Street (B278) past Carshalton station, briefly onto Wrythe Lane, then Wrythe Green Road onto Nightingale Road and Hackbridge Road (both B277). At Hackbridge, turn onto London Road (A237) for Soho Mills, near Hackbridge station.

Head north on West Street past Carshalton station, briefly onto Wrythe Lane, then Nightingale Road and Hackbridge Road to London Road in Hackbridge, about 5 minutes. Collection and delivery can be arranged if you'd rather not drive a car with an MOT corrosion failure.

Directions from Carshalton

About Carshalton

Carshalton is a leafy suburb about a mile east of Sutton, centred on a picturesque village around Carshalton Ponds, a source of the River Wandle. The old village has conservation areas, listed buildings and a village feel, while Carshalton Beeches and Carshalton on the Hill to the south are quieter streets of interwar and Edwardian family homes. To the north, The Wrythe and the Carshalton part of the St Helier estate are more densely built. Around the ponds the roads are narrow and busy, but most of the area is quiet residential driving.

Places nearby: Carshalton Ponds, All Saints Church, Honeywood Museum, Grove Park, Carshalton Water Tower, Carshalton House

Postcodes: SM5 · London Borough of Sutton

More about KITH for Carshalton drivers

Welding & Rust Repair in Carshalton: your questions answered

Why is there water in my footwell after rain?

On cars parked under trees it's very often blocked scuttle, sunroof or door drains rather than a hole in the floor. We check the drains first. If the floor has already rusted through, we cut out the damaged section and weld in new steel.

I scrape the sill on the kerb when parking. Does that matter?

It can. Scraping removes the underseal and paint from the sill edge and jacking points, leaving bare steel that rusts quickly. We can check the area and repair or reprotect it before it becomes an MOT problem.

Is it worth repairing rust on a car I only use around Carshalton?

Low mileage doesn't protect a car from rust, especially one kept outside under trees. If the rest of the car is sound, a sill or floor repair is usually good value. We'll give you an honest view on the ramp before you commit.

Will my car pass the MOT after welding?

We repair the items on your failure sheet to a standard that meets the MOT inspection requirements, although the tester makes the final decision at the retest. If we find other corrosion nearby that's likely to cause a problem, we'll point it out before the retest.

Is it worth welding an older car?

It depends on how much rust there is and what the car is worth. A couple of sill repairs on an otherwise sound car are usually worthwhile. Widespread corrosion across floors, sills and mountings can cost more than the car is worth, and we'll give you an honest view.

Can you just patch over the rust?

Not on structural areas. Welding a plate over rotten metal traps moisture so the rust carries on underneath, and a tester can fail it as an inadequate repair. We cut out to sound metal and weld in new steel.

What's the difference between structural and cosmetic rust?

Structural rust affects load-bearing parts such as sills, floors, crossmembers, chassis legs and the areas around suspension and seat belt mountings. Cosmetic rust is on outer panels like door skins and bolt-on wings, which aren't load-bearing and usually only fail an MOT if they leave sharp edges.

How can I slow down rust?

Rinse the underside during winter to remove road salt, keep door and sill drain holes clear, and deal with stone chips early. On older cars, cavity wax in the sills and underbody protection make a real difference, and we can apply them.

Price your welding and rust repair now

Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.

  • Free, about 30 seconds, no sign-up
  • Parts, labour and VAT included
  • 12-month workmanship warranty
  • Collection from Carshalton can be arranged
“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google

Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Loading instant quote…
Chat on WhatsApp