How we handle timing chain replacement at Hackbridge
Chain work is booked in as a block rather than squeezed between other jobs, because the engine sits stripped and open. Before anything comes apart we listen from stone cold, in the first two or three seconds after the key turns, which is when a worn chain and a drained tensioner give themselves away. We scan for stored correlation and camshaft adjuster codes and read the live deviation figures where the engine reports them. If those numbers sit inside the manufacturer's tolerance and the noise is coming from somewhere else, we say so, and you have saved yourself a very large bill.
Once the job is on, cleanliness decides how long the repair lasts. The sump and the cambox are covered while the old chain comes out, and anything that has shed material gets followed up: on engines where broken guide plastic is known to travel, we look at the pick-up and strainer rather than hoping. Chain, guides and tensioner go in as a set, with sprockets and adjusters where they are worn. Stretch bolts on camshaft sprockets and covers are replaced rather than reused, the timing is verified by hand through two full turns, and adaptations are reset on the scan tool.
Two things get talked through before you commit. The first is access: some engines are a day's work from the front of the car, others need the engine or the gearbox out because the chain sits at the flywheel end, and that difference is most of the price. The second is whether the car is worth it, which you will get a straight answer on rather than a sales pitch. If we go ahead, the engine leaves with fresh oil to the correct approval and a new filter, and we will tell you plainly what oil interval to keep to, because that is what wears the next chain.

