Car Tyre Fitting near Mitcham

Squeezing through Mitcham's parked-up terraced streets and queuing at the Figges Marsh signals is hard on tyres, especially sidewalls. Our Hackbridge workshop is about 8 minutes from Mitcham, and we fit and balance most tyres within 30 to 45 minutes.

  • ★★★★★ 4.9/5 from 193 Google reviews
  • ~8 min from Mitcham
  • Mon–Fri 8am–8pm · Sat 8am–5pm
Lexus in for new tyres at KITH Cars Garage & Bodyworks, Hackbridge

Tight terraces and kerbed sidewalls on Mitcham's side streets

A lot of Mitcham's side streets are Victorian and interwar terraces with cars parked on both sides, leaving single-file gaps. Pulling in to let oncoming traffic past usually means tucking close to the kerb, and a scrape along a kerb face can cut or scuff a tyre sidewall as well as marking the wheel. A sidewall is the one part of a tyre that can never be repaired. If you see a bulge, a cut showing cords, or a deep scuff, the tyre should be replaced, even if the tread is fine.

The main roads bring different wear. The A217 London Road through Mitcham is stop-start and bus-heavy, and the Figges Marsh junction with Streatham Road and Locks Lane queues at peak times. Taxi and private-hire drivers who work the A217 and A236 cover a lot of miles, and they tend to find the front tyres going first. Mitcham also has many older, hard-working cars, and on those we pay attention to the date code on the sidewall as well as the tread, since rubber hardens and cracks with age.

Fitting is done properly: the old tyre comes off on the machine with care around alloy rims and pressure sensors, and we check the rim for buckles or corrosion. A new valve or TPMS service kit goes in, the new tyre is fitted the right way round for directional or asymmetric patterns, and the wheel is balanced and torqued to specification. If the old tyres tell us the alignment is out, we will say so before you leave.

Once you are clear of the one-way system round the Clock Tower, head for the Cricket Green near Eagle House, then take Cranmer Road to Carshalton Road and head south past Mitcham Junction into Hackbridge. It is about 8 minutes. You get a written quote before we fit anything, and if a tyre is too damaged to drive on, we can arrange collection.

Tyre Fitting: what’s involved

Your tyres are the only part of the car in contact with the road, so their condition directly affects braking, steering and grip in the wet. The legal minimum tread depth in the UK is 1.6mm across the central three-quarters of the tread, all the way round. Wet-weather grip falls off noticeably well before that, so many drivers change tyres at around 3mm.

The size code on the sidewall, such as 205/55 R16 91V, tells you the width in millimetres, the sidewall height as a percentage of width, radial construction, the rim diameter in inches, the load index and the speed rating. A four-digit date code shows the week and year of manufacture. Getting the right size, load and speed rating matters for safety and for your insurance.

From £20 per tyreWritten quote first
30–60 minutesTypical time in the workshop
3 monthsWorkmanship warranty
4.9★193 Google reviews

Signs you need new tyres

Tread close to the limit

Tread wear indicators are small raised bars in the main grooves. When the tread is level with them, the tyre is at or near 1.6mm and needs replacing.

Uneven wear

Wear on one edge usually points to wheel alignment problems, while wear on both edges or down the centre suggests the tyre has been run under- or over-inflated.

Cuts, bulges or cracks

A bulge in the sidewall means internal damage, often from a pothole or kerb, and the tyre can fail without warning. Deep cuts and cracking also mean replacement.

Tyre pressure warning light

A TPMS light means one or more tyres has lost pressure or a sensor has a fault. It should be checked promptly, and a lit TPMS light is an MOT fail on cars first used from 2012.

Slow puncture

A tyre that needs air every week or two may have a nail, a corroded rim seal or a leaking valve. Many tread punctures can be repaired, sidewall damage can't.

Vibration at speed

A shake through the steering wheel at motorway speeds often means a wheel is out of balance, has lost a weight, or a tyre has internal damage.

Old tyres

Rubber hardens with age even if the tread looks good. Tyres showing cracking or that are many years old are worth inspecting, particularly on low-mileage cars.

When should tyres be replaced?

Replace tyres before they reach 1.6mm, and ideally around 3mm if you want to keep good wet grip. Any tyre with a bulge, a deep cut, exposed cords or sidewall damage should be replaced straight away, whatever the tread depth. Check tread and pressures at least once a month and before long journeys. Where possible, replace tyres in pairs on the same axle so grip and handling stay balanced side to side.

  • Legal minimum: 1.6mm across the central three-quarters of the tread, all the way round
  • Recommended replacement: around 3mm for better wet grip
  • Immediately for bulges, cuts, exposed cords or sidewall damage
  • Check pressures at least monthly and before long trips
  • Replace in pairs on the same axle where possible

How we fit tyres

  1. Check-in and tyre checkWe check the size, load index and speed rating your car needs, the condition of the other tyres, and whether it has run-flats or TPMS sensors.
  2. Remove the wheelThe wheel comes off the car, including locking wheel nuts using your key, and the old tyre is deflated.
  3. Demount the old tyreThe tyre is removed on a tyre machine, taking care around TPMS sensors and with alloy wheels, so rims aren't marked.
  4. Inspect the rim and valveWe check the rim for cracks, buckles and corrosion on the bead seat, and fit a new valve, or a TPMS service kit where sensors are fitted.
  5. Fit and inflateThe new tyre is mounted in the correct direction or orientation for directional and asymmetric tyres, seated on the bead and inflated.
  6. BalanceEach wheel is balanced on a wheel balancer and weights are fitted to remove vibration at speed.
  7. Refit and torqueThe wheel is refitted and the nuts or bolts tightened with a torque wrench to the manufacturer's figure, then pressures are set to the placard.
  8. TPMS and handoverWe reset or relearn the TPMS where required and check for warnings. If the old tyres showed alignment wear, we tell you so it can be checked.

Tyres we fit

We supply tyres to the size, load index and speed rating your car needs, including run-flat and XL reinforced tyres where specified. We can offer choices across premium and mid-range brands to suit your budget and driving, and we will explain the differences honestly. If your car has manufacturer-approved tyres, marked on the sidewall with a code such as a star for BMW or MO for Mercedes, we can source those too.

  • Premium and mid-range tyres in your correct size
  • Correct load index and speed rating, including XL and run-flat
  • New rubber valves, or TPMS service kits for sensor valves
  • Balance weights matched to steel or alloy wheels
  • Manufacturer-approved tyres on request

How long it takes

30–60 minutes

Fitting and balancing one or two tyres usually takes 30–45 minutes, and a full set up to about an hour. Run-flats and cars with TPMS can take a little longer. If your size needs ordering, we will tell you the date when you book.

What’s included

  • Removal and fitting of the tyre
  • New valve, or TPMS service kit where needed
  • Wheel balancing
  • Wheel nuts torqued to specification
  • Pressures set to the manufacturer's figures
  • Environmentally responsible disposal of the old tyre

From Mitcham to our Hackbridge workshop

From the town centre, follow the A217 London Road south to the Cricket Green, then take Cranmer Road (A239) to join Carshalton Road (A237) heading south. Carshalton Road crosses the railway and tram lines beside Mitcham Junction station and, past Beddington Corner, becomes London Road into Hackbridge, where Soho Mills is on London Road near Hackbridge station.

Follow the A217 to the Cricket Green, then Cranmer Road (A239) and Carshalton Road (A237) south past Mitcham Junction to Hackbridge, about 8 minutes. If the tyre is flat or bulging, don't drive on it; we can collect.

Directions from Mitcham

About Mitcham

Mitcham is a largely residential suburb in the east of Merton that grew from an old Surrey village famous for lavender growing, which still features on Merton Council's coat of arms. Its historic core is a string of village greens, from Fair Green and the clock tower in the town centre to the Cricket Green, with the wide open space of Mitcham Common to the south-east. Housing ranges from Victorian and interwar terraces to large council estates such as Phipps Bridge and Pollards Hill. Driving here means a mix of busy A-roads funnelling traffic between Tooting, Streatham, Morden and Croydon, and quiet residential side streets lined with parked cars.

Places nearby: Mitcham Common, Mitcham Cricket Green, Mitcham Clock Tower, Eagle House, The Canons, Church of St Peter and St Paul

Postcodes: CR4 · London Borough of Merton

More about KITH for Mitcham drivers

Tyre Fitting in Mitcham: your questions answered

I scraped a kerb pulling over on a narrow street. Is my tyre still safe?

Look for a bulge, a cut or exposed cords on the sidewall. Any of those means the tyre should be replaced, as sidewall damage cannot be repaired. If you are unsure, bring it in and we will inspect it with the wheel off.

My tyres have plenty of tread but they are quite old. Should I replace them?

Age matters as well as tread. The four-digit date code on the sidewall shows when the tyre was made, and older tyres can harden and crack. We will check the date and condition and give you an honest opinion.

I drive a taxi on the A217. Which tyres wear fastest?

On most front-wheel-drive cars the fronts wear fastest, especially with lots of stop-start driving. Rotating tyres front to rear where the car allows, and keeping pressures right, helps spread the wear.

What does the code on my tyre sidewall mean?

Take 205/55 R16 91V as an example: 205 is the width in millimetres, 55 is the sidewall height as a percentage of the width, R means radial, 16 is the rim size in inches, 91 is the load index and V is the speed rating. The four-digit DOT code, such as 2324, shows the week and year the tyre was made.

Can I fit different tyres front and rear?

Yes, as long as both tyres on the same axle match in size and type. It is illegal to mix radial and cross-ply tyres on the same axle. Some four-wheel drive cars need all four tyres to be closely matched in size and wear, so check before fitting a single tyre.

What is TPMS?

A tyre pressure monitoring system warns you when a tyre loses pressure. Direct systems use a sensor inside each wheel, usually part of the valve, while indirect systems use the ABS sensors to spot a tyre turning at a different rate. All new cars sold in the UK since November 2014 have one.

Do I need a wheel alignment with new tyres?

Not always. If the old tyres wore evenly and the car drives straight, alignment is probably fine. If they wore on one edge, or the car pulls or the steering wheel is off-centre, the alignment should be checked, or the new tyres will wear the same way.

Can a puncture be repaired?

Often, if the damage is in the central part of the tread and within size limits set by the British Standard for tyre repairs. Damage to the shoulder or sidewall, or a tyre that has been driven on flat, can't be safely repaired. Some run-flat manufacturers don't approve repairs at all.

Price your tyre fitting now

Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.

  • Free, about 30 seconds, no sign-up
  • Parts, labour and VAT included
  • 3-month workmanship warranty
  • Collection from Mitcham can be arranged
“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google

Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Loading instant quote…
Chat on WhatsApp